5 in 1 Class 2 Dim J-BOX LED Driver 384W

This 24 volt led power supply for lighting application has universal input range 100-277VAC. Compatible with most ELV & MLV dimmers. led strip lights can work with that. Model SMT-024-384VTD52JV2 SMT-048-384VTD52JV2 Output DC Voltage 24V 48V Rated Current 4*4A 4*2A Rated Power 384W (4*96W) 384W (4*96W) Voltage Tolerance ±0.5V Voltage Regulation ±0.3% Load Regulation ±1% Input Voltage Range 100-277VAC Frequency Range 47-63Hz Power Factor@ full load 0.98@120VAC   0.96@277VAC 0.98@120VAC   0.96@277VAC THD@ full load <20% Efficiency@ full load 87%@120V 90%@277VAC 88%@120V 91%@277VAC AC Current(Max.) 4.6A@100VAC 4.6A@100VAC Inrush Current (Typ.) 22.8A ,50%,960us @120VAC ; Leakage current <0.50mA Protection Short Circuit shut down o/p voltage, re-power on to recover after fault condition is removed Over Loading ≤120% Hiccup mode ,recovers automatically after fault condition is removed Over temperature 100℃±10℃ shut down o/p voltage, automatically recover after cooling. Environment Working TEMP. -40~+60℃ (see below derating curve) Working Humidity 20~90%RH, non-condensing Storage TEMP. Humidity -40~+80℃,10~95%RH TEMP .coefficient ±0.03%/℃(0~50℃) Vibration 10~500Hz, 5G 10min./1 cycle,period for 60min. each along X,Y,Z axes Safety&EMC Safety standards UL8750+UL1310 Withstand voltage I/P-O/P:1.88KVAC Isolation resistance I/P-O/P:100MΩ/500VDC/25℃/70%RH EMC EMISSION FCC 47 CFR Part 15 ,Subpart B Others Weight 2.6Kg   Size 323*140*47.5mm (L *W*H) packaging 10pcs /CTN    385*335*200mm     20PCS/CTN Notes 1. All parameters if NOT specially mentioned are measured at 120VAC input , rated load and 25℃of ambient temperature. 2. To extend the driver's using life ,please reduce the loading at lower input voltage. [Custom Product Tab] Input wire 18AWG Black and White to be connected to AC L and N ,Green wire go ground Output cable 2*16AWG,Red" (+) to LED Positive side (+) , "Black"(-) to LED Negative side (-). Dimming cable 2*18AWG,DIM (+) Purple to 0/1-10V dimmer signal(+ ),DIM (-) Grey to 0/1-10V dimmer signal (-) Please DO NOT connect ¡°DIM-¡° to ¡°LED-¡°, ¡°DIM+¡± to ¡° LED+¡± ,or other incorrect connection. Please make sure your connect these correctly otherwise your product will not function correctly and could be damaged. ¡ö?Connecting Diagram Using TRIAC/Phase cut dimming 1.The Pulse-Width Modulation (PWM) of output voltage can be adjusted through input terminal of the AC phase line(L) by connection a phase /Triac dimmer of lighting system. 2.Work with forward phase /leading edge ,MLV and?reverse phase /trailing edge ,ELV,TRIAC dimmers. 3.Please try to use dimmers with power at least 1.5 times as the output power of the driver. ?Using 0-10/1-10V dimming ? [/Custom Product Tab]