5 in 1 Dim J-BOX LED Driver 150W

We promise to give 7 years warranty of this dimmable driver led 150w. It is easy for installtion with power cables. Leviton dimmers 110V and 277V can work well with that. model SMT-012-150VTDHV2(1.0version) SMT-024-150VTDHV2 (1.0 version) SMT-012-150VTDHWV2(2.0version) SMT-024-150VTDHWV2 (2.0 version) Output DC Voltage 12V 24V Voltage Regulation ±0.5% Rated current 12.5A 6.25A Voltage Tolerance ±0.5V Load Regulation ±2% ±2% Rated power 150W 150W Input Voltage Range 110-277VAC Frequency Range 47-63Hz Power Factor@ full load 0.98@120VAC  0.95@277VAC 0.99@120VAC  0.94@277VAC THD(Typ.)@ full load <20% Efficiency @ full load 85% @120Vac      86%@277Vac 85% @120Vac      87%@277Vac AC Current(Max.) 1.8A@100Vac Inrush Current (Typ.) 15A, 50%, 1.4ms @120Vac     30A, 50%, 1.4m,s @277Vac Leakage current <0.50mA protection Short Circuit shut down o/p voltage, re-power on to recover after fault condition is removed Over Loading ≤120% constant current limiting, auto-recovery Over temperature 100℃±10℃ shut down o/p voltage, automatically recover after cooling. Environment Working TEMP. -40~+60℃ (see below derating curve) Working Humidity 20~90%RH, non-condensing Storage TEMP. Humidity -40~+80℃,10~95%RH TEMP .coefficient ±0.03%/℃(0~50℃) Vibration 10~500Hz, 5G 10min./1 cycle,period for 60min. each along X,Y,Z axes Safety&EMC Safety standards UL8750+UL1310 Withstand voltage I/P-O/P:1.88KVAC   Isolation resistance I/P-O/P:100MΩ/500VDC/25℃/70%RH EMC EMISSION FCC Part 15 B Others Weight About 1.8Kg Size 1.0 version: 260*105*45mm / 2.0 version: 260*125*45mm  (L*W*H) packing 10PCS/CTN (L*W*H) Notes 1. All parameters if NOT specially mentioned are measured at 120VAC input , rated load and 25℃of ambient temperature. 2. To extend the driver's using life ,please reduce the loading at lower input voltage. [Custom Product Tab] Inputwire Black and White to be connected?to?AC?L and N ,Green wire go ground, Outputwire?Red to LED Positive side (+) , Black ?to LED Negative side (-).?? Dimming cable DIM (+) Purpleto 0/1-10V dimmer signal(+ ),DIM (-) Grey?to 0/1-10V dimmer signal (-) ? Please make sure your connect these correctly otherwise your product will not function correctly and could be damaged. ¡ö?Connecting Diagram Using TRIAC/Phase cut dimming 1.The Pulse-Width Modulation (PWM) of output voltage can be adjusted through input terminal of the AC phase line(L) by connection a phase /Triac dimmer of lighting system. 2.Work with forward phase /leading edge ,MLV and?reverse phase /trailing edge ,ELV,TRIAC dimmers. 3.Please try to use dimmers with power at least 1.5 times as the output power of the driver. ?Using 0-10/1-10V dimming ? [/Custom Product Tab]