ZIBOO TP88A Piercing Needle Non-destructive Test Probe Use for Digital Multimeter Test Leads

►Rigid Back Test Pin Set►2" Long Pins Pass Between The Weather Pack Seal and Wire►A Sharp Point Ensures Good Contact To the Electrical Connector, and The Pin's►Insulation Protects It From Shorting to Other Wires►Slides Onto Test Probes Measuring 2mm ,Tested to 60VDCProduct featuresThe probe tip diameter is only 0.2mm, and the hard and thin tip is suitable for measuring tiny IC pins, LED lamps, and small componentsWide range of applicationsPrecise measurementIt is suitable for precision narrow scene measurement, easy puncture of thin gauge needles, small measurement of wire harness damage,OBD automotive on-board diagnostic systemCompatible with a 2mm multimeter stylus, it is easy to connect and facilitate measurement in precise and narrow scenesRigid Back Test Pin Set2'' Long Pins Pass Between The Weather Pack Seal and WireA Sharp Point Ensures Good Contact To the Electrical Connector, and The Pin'sInsulation Protects It From Shorting to Other WiresSlides Onto Test Probes Measuring 2mm ,Tested to 60VDC​Pattern Name:TP88ABrand : ZIBOOModel: TP88A Red+BlackRated Voltave:CAT II 600VRated Current :10A Diameter:Φ2mmBetter than a test probe alone ,These two inch long rigid back probe pins easily pass between the weather pack seal and wire.A sharp point ensures good contact to the electrical connector,and the pin's insulation protects it from shorting to other wires.