PM06D Power Module (14S)

This PM uses I2C digital signal data output, only compatible with Pixhawk 5X/6X series. PM06D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Specification Input voltage: 2S- 14S PCB Cont. Current Rating: 70A PCB Burst Current Rating: 120A (<60 Sec) Max current sensing: 327A Voltage and current monitor with I2C compatible interface  Connector Outputs: 5.2V and 3A max  Weight: 24.5g Current Rating: The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly.  PX4 Parameter Setup: If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable. Package Includes： 1x  PM06D Power Module 1x  6pin 2.00mm pitch cable