GM LS & LT Standalone Tuning using Holley Terminator X

Are you ready to take control of your GM LS/LT build, while taking your knowledge to the next level of performance?  Holley Terminator X training from The Tuning School is here to help.  Learn how to properly install and set up your Terminator X and Max devices, while also learning a safe and repeatable process for tuning.   Supported modifications for this course:  heads/cam, bolt ons, and forced induction setups.   Course Topics: Basic Setup - Hardware Sensors and Actuators Software Operation Software Setup Datalogging Basics Critical Parameters Setup Tuning Topics (for N/A and Forced Induction combinations) Fuel Injector Sizing Engine Size Idle/Part Throttle Tuning Speedometer and Rear Gear Calibration Engine Cooling Controls Timing Table Updates Fuel Table Updates Airflow Table Updates WOT Tuning Drive by Wire Throttle Response Working with the Learn Table Target A/F Ratio Transmission Tuning Supported Engines: LS1/LS6, LS2/LS3, LS 24X 4.8/5.3/6.0 Trucks, LS 58X 4.8/5.3/6.0 Trucks, and Gen V LT applications.  Supported Transmissions: 4L60E and 4L80E (LS Specific) and 4L60 and 4L80 (LT Specific)