Universal Treadmill Motor Controller Top Console Diplay Control Board+Screen Treadmill Controller Sets for 0.75-4.0HP motor

Universal Treadmill Motor Controller Top Console Diplay Control Board+Screen Treadmill Controller Sets for 0.75-4.0HP motor Note! This controller set 100% can work without a speed sensor, So don't worry about that!  1. Condition: new 2. 3months warranty 3.Test working before shipping 4. Applied for motor power from 0.75-4.0HP  DC motor only 5. This controller set have tow options, with INCLNE & without INCLNE. Pls check the photo below Console size:30cm*17cm Controller Controller Technical Parameters: size: 130mm * 100mm * 70mm Input voltage:[AC] AC85V ~ 255V Sensor mode: Magnetic sense / light perception / no sense [default no sense mode] Features: 1: set the sensor mode by setting; set the minimum speed and maximum speed; set the output torque size; speed calibration 2: overcurrent and speed protection 3: Output short circuit or open circuit protection 【Display:】 digital tube, LED display; touch button; 【Display content】: treadmill speed, exercise time, movement distance, calories and slope 【Key Function:】 start / stop key, mode setting key, speed plus or minus key, slope plus or minus key, speed shortcut key,   slope shortcut key; 【Dashboard function:】 countdown mode, distance countdown mode, calorie countdown mode, motion built-in program; 【Installation:】 can be fixed with double-sided adhesive in the original shell surface; or embedded into the original  treadmill instrument panel display window;  Instructions  1: press the start button, there are 3 seconds countdown, treadmill began to run;  2: press the stop button, treadmill slow down and stop  3: mode key: standby, press the mode key, enter the run mode settings;  4: After the treadmill is started, adjust the speed by speed addition or subtraction or speed shortcut keys  5: After the treadmill is started, adjust the treadmill slope by raising the plus or minus key Error code E1 communication failure E2 power tube breakdown E3 Sensor malfunction E4 over-current protection motor has a problem E5 Motor fault The motor is completely broken             6 The last step: put the security lock up, Finish setting. NO Parameter definition Unit Defaults value Programming range 101 Min speed KM/H 1.O 0.5~3.0 102 Max speed KM/H 12.O 3.0~16.0 103 Speed calibration ——— 13.5 1.0~20.0 104 Reservation ——— ——— ——— 105 Lifting mode ——— 10.O ——— 106 Sensor mode ——— 22.1 107 Output torque setting ——— 3.O 0.5~20.0 108 ——— ——— ——— ——— 109 ——— ——— ——— ——— Pay attention: (1) 103 corresponds to the motor speed calibration, the greater the set value, the smaller the motor output speed; if without sensor, 103 corresponding to the larger the value, the greater the motor output speed. (2)105 corresponds to the lift control mode; Ø  105 = 10.1 means can lift; Ø  105 = 10.0 means can not lift (3) 106 corresponds to the sensor mode; Ø  21.9 means with light sensor Ø  22.0 means with magnetic sensor; Ø  22.1 means without sensor (4) 107 corresponds to the size of the motor output torque, the greater the set value, the greater output torque. After each setting of a parameter, be sure to click the "Start / Stop" button, to save the set parameters; Please make sure that there is no problem with the motor before you place your order.The motor can be tested by the method shown in the picture below. If the motor running smoothly by 5# battery, that means the motor is good. If running not smoothly or do not running, it means the motor broken.