
Skystars F405 Mini HD2 Flight Controller (20x20 / 6 Uarts / 3-6S)
Introducing the Skystars F4 HD2 Flight Controller, featuring 6 Uarts, a 20x20 mounting pattern, and a 10V 2A pad for DJI Air Units, Vista Kit, or other VTXs. This Flight Controller also has a great layout with easy-to-reach solder pads for your convenience, plus comes equipped with a Barometer for Betaflight and INAV RC Drone FPV Racing. FEATURES: Capability to use M2 and M3 screws using Rubber Grommets included. Solder pads are large and easy to reach. Proper solder pad spacing to avoid solder bridges. ESC connector on top-side rather than bottom which makes it easier to reach for repairs. TVS Diode for Reverse Polarity Protection and Voltage Spike Suppression. Powerful BEC to work with all your electronics. Pad arrangement makes sure there are no wires overlapping when you twist the wires of the camera, VTX, and RX, for a uniform twist and a clean look. DJI connector on the bottom side. Two stages of quality checks to reduce any faulty electronics. No power lines near Gyro to avoid any EMI interference. Ready with I2C and INAV support. SPECIFICATIONS: Input voltage: 3-6S LiPo (11.1V~22.2V) MCU: STM32F705RGT6 168MHz IMU: MPU6000 (SPI) OSD: Betaflight OSD & DJI HD OSD (UART6) UARTS: 6 Receiver: TBS/PPM/SBUS/IBUS/DSM Barometer: No Buzzer Pad: Yes CURR Pad: Yes BEC: 5V 2A & 10V 2A (Max 3A) Blackbox: 16MB Firmware: Betaflight / INAV SKYSTARS F405HD Mounting Holes: 20 x 20mm / M3 or M2 Weight: 0.16oz (4.8g) HELPFUL LINKS: Wiring Diagram INCLUDES: (1) Skystars F405 Mini HD2 Flight Controller(5) M2/M3 Rubber Dampeners (Orange)(4) Rubber Dampeners (Red)(1) 8-Pin ESC to FC Cable NOTES: Manufacturer upgrades, alterations, and processor/firmware changes frequently made without prior notice. Exact specifications, photos and links cannot be guaranteed.