Williams Rollergames Main Ramp R-13510

If you miss out on this run, more are coming in the next 10 days. This ramp is made from the original 3/16" thickness material as the original, but the plastic distribution is better at the ramp entrance and exit. These areas were paper thin on the original ramp, and are now 3x thicker on average.Note: this ramp requires an above average amount of work to install You will have to transfer over the flasher boards and flasher domes from your original ramp. There are currently no aftermarket sources for these boards. Remove them with care from your old ramp. The flasher dome holes are sized for 6-32 thread cutting screws. If your screws are gunked up and do not bite well, an 8-32 machine screw will fit the holes in the domes and thread nicely into these same holes. You could also use a slightly longer 6-32 machine screw with a nut. Take note as to the direction the domes are mounted. The rivet holes for the flasher boards are machined slightly larger than the dome screw holes. I used 9/32