Diablo DSP-10LV Loop Detector Without Harness

Diablo DSP-10LV Loop Detector The DSP-10 vehicle detector has been specifically designed to handle all parking, drive-through and access control applications. Loop Size - Works on any in-ground inductive loop from 20 to 1000 uH.Power Brownout Call Memory – Power interruptions of short duration are ignored. If power fails for approximately three seconds or less the DSP-10 “remembers” a vehicle. Intelligent Power Protection – The DSP-10-LV is protected from damage if plugged into a higher voltage. No need to change a fuse or reset a circuit breaker, simply plug the detector into the proper voltage and it works. Indicators - Separate Power/Fail and Detect LEDs. Compact Size - Industry standard 11 pin connector in a small plastic case. FRONT PANEL SELECTABLE SWITCHES Sensitivity - Ten sensitivity settings. Frequency – Automatically tunes within one of four operating ranges. Outputs - Two separate relay outputs with features that are front panel programmable as follows: Output A - Main detection output. Can be modified by delay and extension. Factory set to be fail safe. Fail mode operation is easily changeable by internal jumpers. Output B - Can be set to one of the following: 1) True presence (no extension or delay) 2) Pulse on vehicle entering loop 3) Pulse on vehicle exiting loop 4) Loop Fail output Sensitivity Boost - Can be used in special applications to insure complete detection of high-bed vehicles. Hold time - Normal or extended hold time is selectable. Loop failure - If the loop fails (opens or shorts) the power indicator flashes. Output B can also indicate this condition if desired (see above). The option to "remember" an intermittent loop failure is also provided. Delay - Can be selected to ignore fast moving vehicles over the loop. Extension - Extends a call for slow moving vehicles.