PolyWise Ultra - Metallic Pigment
Metallic Pigment Metallic Pigment for PolyWise Ultra - 120 grams Mixing Instructions: With a clean mixing tool, mix part A individually at low speed (300- 450 rpm) for two minutes. Then add the metallic pigments in part A. With a clean mixing tool, mix for two to three minutes , until a homogeneous mixture is obtained. These premixing steps should be performed to minimize unwanted effects including circles or comet drags. A variation in pigment concentration among different mixtures could have a perceptible impact on the effect and color perception.Make sure to maintain the same ratio throughout the entirety of each project. In a clean container free of any external particles, combine two parts A to one part B. With a clean mixing tool, mix thoroughly for three minutes or more, until a completely homogeneous mixture is obtained. Use a low-speed drill type mixer (300- 450 rpm) to minimize air entrapment in the product.It is recommended to activate the mixer in the reverse mode after the first 90 seconds for the liquid to mix from the bottom of the mixing can to the top. Make sure to scrap sides and bottom of mixing container so no unmixed material remains. Only mix the quantity of product required depending on the pot life and the working time required.It is one metallic pod per part A therefore, 2 metallic pods per 3 gal epoxy kit. (Our metallic pods are 120gr : 4.2 OZ ) (4.2 OZ of metallic pods per epoxy gallon)