RDL TX-VCR Video Controlled Relay BNC

Video Controlled Relay - BNC The TX-VCR is the ideal choice in installations where a control signal is needed based on the absence or presence of valid video signals. The unique power supply input allows the TX-VCR to be powered from a wide variety of existing ac or dc power sources The TX-VCR has one video INPUT and a LOOP OUT video jack. The detection circuit bridges a 1V video line. The TX-VCR may be inserted in a video line with the loop-through video output feeding a terminated load. It may alternatively be installed at the end of a video line by installing a 75 Ω terminator to the LOOP OUT video jack. The terminator is supplied with the TX-VCR. Video detection is based on valid sync signals. The TX-VCR responds to valid NTSC or PAL sync while ignoring 50 Hz and 60 Hz hum and related induction artifacts. The TX-VCR is able to detect signals as weak as 0.5 V p-p. When a valid signal is detected, the relay contacts close. Both a normally-open and normally-closed contact are provided, permitting the module to be connected as a video-present detector or as a video-loss detector. The front-panel SYNC LED lights when valid video is being detected. If a local or remote loss of video audible alert is needed, the TX-VCR may be wired to an RDL BZR.Features: Detect Video Presence Detect Loss of Video Bridging or Terminated Operation Detection of NTSC or PAL Signals Dry-Contact Outputs Operation from AC or DC Power Specifications: Input:BNC, ground-referenced Input Level:0.5 V p-p video to 1 V p-p video Output:LOOP OUT, BNC, ground-referenced (Output must be terminated with 75 Ω connected load or with 75 Ω terminator supplied) Control Output:N/O or N/C relay contacts Relay Contacts:Single-pole/double-throw Maximum Switching Power:60 W (220 Vdc, 125 Vac, 2A) Power Requirement:GROUND-REFERENCED, 12 to 33 Vdc or 12 to 24 Vac, @ 75mA Ambient Operating Environment:0 C to 55 C