Lectrosonics M2TND, RACK IEM/IFB TRANSMITTER, DIGITAL DUAL STEREO

Descriptions Lectrosonics M2TND, RACK IEM/IFB TRANSMITTER, DIGITAL DUAL STEREO The Lectrosonics M2TND is an IEM Digital Half-Rack Transmitter. The Lectrosonics M2TND features transmission power up to 50 mW for extended operating range and locking XLR/TRS combo connectors, that facilitate up to four channels of analog audio sources. With ultra-low latency, 24-bit audio, and two stereo-digital channels, the Lectrosonics M2TND is an IEM transmitter for professional broadcast applications. Also, the Lectrosonics M2TND is built with a USB port for firmware updates and an IR port for fast setups, the Lectrosonics M2TND transmitter has a large, high-resolution backlit color LCD with large membrane switches for an intuitive interface visible in daylight or dimly-lit conditions. Analog signals are converted to an internal 24-bit digital format that is encoded, organized into packets, and passed to an RF modulator. The RF signal is filtered before and after amplification to suppress out-of-band noise and spurious signals. Additionally, the Lectrosonics M2TND transmitter employs a technology that provides a frequency response from 20 Hz to 15 kHz with maximum channel separation. This digital audio technology eliminates a compandor and the associated artifacts, resulting in crystal clear sound, rock-solid stereo imaging, and low distortion. Lectrosonics M2TND Main Features IEM Wireless Monitor with Digital RF 24-Bit Digital Audio USB Port for Firmware Updates Analog Inputs Specifications RF Power Output 2 x RF carriers, 2 audio channels each10, 25, or 50 mW; adjustable Antenna Output 2 x BNC sockets Operating Frequencies 470 to 608 MHz Frequency Selection Steps 25 kHz Frequency Stability ± 0.002% Modulation 8 PSK Emission Designator 200KG7E Spurious Radiation Compliant with ETSI EN 300 422-1 Equivalent Input Noise -128 dBV Audio Frequency Response 20 Hz to 15 kHz Audio Input -10 dBV or +4 dBu settings with ±5 dB trim Audio Input Jack 4 x combo XLR/TRS connectors Dante Connection Not applicable Ethernet Connector RJ45 USB Micro USB on the front panel for firmware updates IRDA IR transceiver for sync of receivers Input Impedance Line: 2 kOhms Headphone Jack 1/8" / 3.5 mm stereo Power Requirements 9 to 18 VDC Power Consumption 5 W Dimensions (H x W x D) 1.8 x 8.4 x 7.8" / 4.4 x 21.3 x 19.7 cm Weight 6.35 lb