Manta E3ez 32bit Motherboard Manta E3ez Board For 3/ 3pro/ 5 Cr10 3d Printer
mickcara.com

Manta E3ez 32bit Motherboard Manta E3ez Board For 3/ 3pro/ 5 Cr10 3d Printer

$134.49
{{option.name}}: {{selected_options[option.position]}}
{{value_obj.value}}
Store Logo

mickcara

View Store

1.32bit 64MHz ARM -M0+ series STM32G0B1RE MCU. 2.TPS5450-5A power supply chip supports DC12/24V power input, current output rated at 5A max continuous and 6A max instantaneous, sufficient power supply for . 3.The thermistor circuit is to prevent MCU damage from shorted heated bed and heater connections. 4.MCU firmware can be upgraded via SD card, or use DFU via Klipper's make flash . 5.BTB connectors are adopted between the motherboard and core board, allowing the choice of other core board solutions in addition to CM4. 6.Onboard SPI and UART mode of EZ driver, which can be used directly without a jumper. 7.Onboard DIAG pin, configurable with . 8.Support power loss , filament runout sensor, auto power-off, BLTouch, RGB, etc. 9.High-efficiency MOSFET for less heat generation. 10.Replaceable fuse for easy maintenance. 11.Onboard SPI interface for connecting acceleration sensor to enable Klipper's input shaping. 12.The temperature sensor interface adopts a high-precision pull-up resistor.

Show More Show Less