BLDC ESC V4 Compatible with VESC® Tool*

Now Ships with Pre-Soldered XT90 Connector. The BLDC ESC is based upon the Hardware V4 VESC® Open Source Project, and compatible with VESC® Software. The BLDC ESC V4 is a highly modifiable electronic speed controller designed for DIY Electric Skateboards conversions in mind. The BLDC ESC V4 allows you to use sensorless motors to achieve smooth start-up from a stop, while traditional RC ESC's may have trouble starting. It also provides strong reliable and progressive electric braking. Comes with pre-soldered 4mm bullet connectors. (Compatible with all MBoards Motors).  Capable of BLDC and FOC mode.  Customizable settings with VESC® Tool.  This hardware 4 ESC is based on a beta technology and requires special care and set up.  Specs: ◆ Hardware: V4◆ PCB:4 layers, size: 40*60mm◆ Current: 50A continuous / 240A peak◆ Voltage: 8V-60V (Cells: 3s-12s)◆ BEC: 5V@1.5A◆ BEC type: Internal driver support ◆ Timing: Software calibration ◆ Motor control interface: PPM signal (RC servo), analog, UART, I2C,   USB or CAN‐bus. ◆ Cutoff Voltage: Programmable◆ Frequency: PWM input ◆ Governor: No◆ Weight: 80g◆ BLDC ESC V6 Size: 120x40x20mm◆ Programming card: No◆ Reverse: Yes What's In the Box?  (1) BLDC ESC 4(1) USB-C Cable(1) PPM cable soldered on board   *VESC is a registered trademark owned by Benjamin Vedder.VESC Hardware by Benjamin Vedder is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License. For more Information and to download the PC software please visit (http://vedder.se/2015/01/vesc-open-source-es-c/) . Vesc 6 Pictured, due to chip shortages we are only able to get V4 Vescs at the moment.