SECO-LARM MVE-AH1E1-01NQ HDMI Extender over Single Cat5e/6

SECO-LARM MVE-AH1E1-01NQ HDMI Extender over Single Cat5e/6 The ENFORCER HDMI Extender over Single Cat5e/6 extends the range of traditional HDMI cabling methods by using an active transmitter and receiver to send video and audio over a single Cat5e/6 cable. HDMI formats as large as 1080p can be transmitted up to 164ft (50m) between the two units with zero signal loss by using integrated circuits in the receiver and transmitter. The extender also supports HDMI loop output, EDID management settings, and one way IR control for remotely controlling HDMI sources and displays. Feature: Extend HDMI over a single Cat5e/6 cable Supports resolutions from 480i to 1080p with zero signal loss Transmits up to 164ft (50m) at 1080p over Cat5e/6 cable HDMI Loop output for local HDMI display Plug and play operation – comes as a complete set IR Pass-through for remote control extension and operation EDID Management switch Two (2) 5VDC power supplies included Specifications: Input Video Signal 3.3V Input DDC Signal 5Vp-p (TTL) Deep Color 24-Bit Video Format Supported High-speed HDMI, HDCP 1.2 Audio Formats Supported LPCM, Dolby-AC3, DTS7.1, DSD Output Video HDMI® Resolutions Supported 1080p/1080i/720p/576p/576i/480p/480i Range – 4K Up to 164′ (50m) Video Amplifier Bandwidth 4.95Gbps Maximum Input Cable Length 24AWG (15m), 26AWG (10m), 28AWG (5m) Video Input Connector HDMI Type A 19-pin female IR Pass-through Frequency 30~60 kHz Operating Voltage 5VDC Power Supply 1A@5VDC (2 Adapters) (2.1mm plug) ESD Protection (Human Body Model) ±8kV (Air-gap discharge), ±4kV (contact discharge) Cat5e/6 Wiring Standard T568-B Current Draw Transmitter- 300mA@5VDC Receiver- 200mA@5VDC Operating Temperature 32°~104° F (0°~40° C) Operating Humidity 20~90% RH (no condensation) Dimensions 31/8″x11/16″x25/8″ (79x17x67 mm) Weight 5.3-oz (150g) (Each) Maximum Single Link Range 1080p Troubleshooting: HDMI device does not function correctly Use T568-B wiring standard Make sure the extender is powered on both sides Make sure the source and display are powered Test the Cat5e/6 cable between the receiver and the transmitter to make sure it is functional Make sure there are no problems with the HDMI source, HDMI cables, or HDMI display by plugging the source directly into the display using an HDMI cable Screen flickering or brief image loss Use a higher grade of twisted pair category cable (Cat6 is recommended) Switch the source device to a lower HDMI output (i.e., 1080p to 1080i) Power down the unit then move the EDID switch to the opposite position and re-power the unit Restart the handshake process by powering everything down then powering up and connecting each device in succession starting with the HDMI source Download: Product Information Sheet Manual