GM4108H-120T Encoder Combo Set

DescriptionEncoders are special sensors that are added to each brushless motor of a Gimbal Stabilizer allowing the system to more accurately track motor position for increased stability which in turn also increases battery efficiency. What's encoder technology in brushless gimbal control system? The 3 axis stabilization gimbal system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization relies on the principles of inertia (the tendency of an object to resist change in its motion) and requires that the camera is well-balanced in the Pan, Tilt, and Roll Axes. Active stabilization refers to the techniques of using sensors to measure the camera’s Pan, Tilt, and Roll movements and counteract those movements using motors attached to the 3 axes. FeaturesEasy to do gimbal tuning, no need to do much calibration work anymore.Power saving, 5 times long working time than gimbal without encoder system.Twin IMUs.Faster response, motor torque increasing instantly, no bug for difficult rotating angle anymore.Encoder chip A5048a GM4108 Gimbal Motor SpecificationsModel: GM4108HMotor Out Diameter: Ф47±0.05mmConfiguration: 24N/22PMotor Height: 32.3±0.2mm (Included with Encoder housing)Hollow Shaft(OD): Ф10-0.008/-0.012mmHollow Shaft(ID): 8+0.05/0mmWire Length: 265±3mmCable AWG: #24Motor Weight: 137±0.5gWire plug: 2.5mm dupont connectorNo-load current: 0.07±0.1ANo-load volts: 20VNo-load Rpm: 513~567 RPMLoad current: 1.5ALoad volts: 20VLoad torque(g): 1200-1800Motor internal resistance: 11.1Ω±5%（Resistance varies with temperature）High voltage test: DC500V 1mA@2secRotor housing runout: ≤0.1mmSteering (axle extension): ClockwiseHigh-low temperature test：High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperatureLow temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperatureMaximum power: ≤25WWorking current: 3-5SWorking temperature: -20~60℃;10~90%RH Packing List3 x GM4108H-120T Gimbal Motor with AS5048A Encoder & Magnet1 x Alexmos 32BIT BGC Board Encoder version without alum case1 x Connecting cables set