SpeedyBee V3 F722 3-6S 30x30 Stack/Combo (F722 FC / 50A 32bit 4in1 ESC)
The SpeedyBee V3 F722 3-6S 30x30 Stack/Combo (F722 FC / 50A 32bit 4in1 ESC) is a marvel to behold. The latest iteration of the SpeedyBee Stack, the V3 is packed with powerful new upgrades. Faster Wi-Fi upgrades, black box retrieval within a minute, supports up to 8 motors, and features soldering pads on one end, and pin connectors on the other in case soldering isn't your thing. The 50A 4in1 ESC is fitted with a high-quality CNC heat sink shield to significantly reduce the heat from your MOSFETs ensuring stable current flow at a high-throttle position. This ESC should have no issues with overheating. A great benefit in a stylish blue finish. Specifications F722 2-6S Flight Controller MCU: STM32F722 IMU: BMI270 USB: Type-C Baro: BMP280 (I2C) OSD: BetaFlight OSD w/ AT7456E chip BLE Support, used for Flight Controller configuration WiFi Support, used for data transfer, e.g firmware flashing, and Blackbox analysis. DJI Air Unit plug: A full DJI Air Unit JST slot onboard BlackBox: 500MB onboard data flash BetaFlight Camera Control Pad: Yes Power input: 3S - 6S Lipo 10 groups of 5V output, three +5V pads and 1 BZ+ pad (used for Buzzer) on front side, and 6 +5V output included in the connectors on bottom side. The total current load is 2A. 2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 4A. Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load. Supported. Designed for 3.3V-input receivers. Up to 500mA current load. ESC signal M1 - M4 on bottom side and M5-M8 on front side. UART: 5 sets (UART1, UART2, UART3, UART4, UART6) ESC Telemetry: UART UART4 RX I2C: Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc. LED: Used for WS2812 LED controlled by Betaflight firmware. Buzzer: BZ+ and BZ- pad used for 5V Buzzer Boot button: Yes RSSI input: Yes SmartPort: Supported Support Flight Controller Firmware: BetaFlight(Default), EMUFlight, INAV Target: SPEEDYBEEF7V3 Mounting: 30.5x30.5mm, 4mm hole size Dimension 41(L) x 38(W) x 8.1(H)mm Weight 9g 32Bit 50A 3-6S 4in1 ESC Firmware: SpeedyBee BL32 50A Continuous Current: 50Ax4 Burst Current: 55A(5S) Power input: 3S - 6S LiPo Power output: VBAT Current Sensor: Supported (Scale=490 Offset=0) Mounting: 30.5x0.5mm, 4mm hole size Dimension: 45.6(L)x40(W)x8.8mm(H) Weight: 19.2g with heat sink Includes 1x SpeedyBee BL32 32bit 50A 3-6S 30x30 4in1 ESC Wiring Diagram