Matek ELRS-R24-P6 ExpressLRS 2.4GHz PWM Receiver

ExpressLRS is a control link for those looking for ultra-low latency and long-range. The Matek ELRS-R24-P6 is a 6-channel 2.4GHz PWM receiver, perfect for those needing connectors for servos.  Specifications: ESP8285, SX1281 Antenna connector: IPEX MHF 1 6x PWM outputs Support 2~8S VBat voltage sense RF Frequency: 2.4GHz (2400~2480MHz) Telemetry power: 12dbm Receiver output protocol: PWM Input voltage: 4~9V DC @ “+” pad Voltage sense: 34V Max. @ “VBat” pad Power dissipation:  45mA(binding), 85mA(wifi mode) PCB size: 20mm x 18mm Weight: 2g w/ antenna Firmware ExpressLRS 3.0 or newer, DIY 2.4 GHz / DIY 2400 RX PWMP EX ExpressLRS wiki for PWM receiver, Click HERE Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer Receiver has ExpressLRS 3.0 preloaded with binding phrase “123456”, the Receiver will never enter binding mode if using the traditional binding procedure. You need to reflash it with your binding phrase OR go into WebUI to set your binding phrase. Flashing via Wifi Disconnect ESC and servos from receiver first. Power on receiver by 5V source. Receiver’s LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it’s on Wifi Hotspot Mode. More detailed steps, pls refer to ExpressLRS websitre Target: DIY 2.4 GHz / DIY 2400 RX PWMP EX Flashing via UART Disconnect ESC and servos from receiver first. Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver. Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid. Select the target DIY 2.4 GHz / DIY 2400 RX PWMP EX and “UART” for Flashing Method, set your bind phrase and Firmware Options and once done, click on Build and Flash. Includes:1x Matek ELRS-R24-P6 ExpressLRS Receiver1x IPEX MHF1 Antenna 15cmDupont 2.54 pins (unsoldered)