Honda custom map lights interior kit, pair - Wedge type - 168, T10

Made in USA   Comparison photos to stock begin at 5:23       To Remove light covers & replace light:     Map Lights - 1:00   1. Use provided tool, (recommended to cover the tip with plastic to prevent the scratch), push in to middle side of cover edge lift up and pull down. Should pop out, then repeat for the other side. 2. Pull down on stock light to remove, push new light in (it does not snap just push until its in). If it does not light then pull it out and flip it around and re-install. 3. Push cover back on, will snap in to place     Vanity Lights - 3:31 1. With provided tool, at the bottom there is a inverted tab just insert the tool and lift up the cover will pop loose. 2. Pull the stock light out, push in the new light that its secure in the middle of the prongs. If it does not light then pull it out and flip it around and re-install. 3. Push the cover back in until it snaps in to place     Trunk Light - 3:51 1. Pull down on the light cover from both sides, the cove