RGB Backlight Controller V3

Have you already gone through the challenge to install an RGB backlight to your DMG? The next evolution is active control of the RGB pallette via the Game boy keypad. This tiny board will let you set the colour of your backlight to 1 of 16 million possible combinations and remember it the next time you turn your gameboy on. V3 boards are much simpler to install, 2 wires for power, 2 wires for keypad sensing, and 3 wires for your RGB module You will need to solder wires to the flat flex connector on the PCB, or various other points, which ever you find easiest. You must use the existing resistors used in your RGB install, Don't omit them or you will damage your backlight and my module! Free economy shipping (Untracked, uninsured, posted in an envelope) If you prefer tracked shipping, that is available too. Guide: - There are 7 pads on the module. + and - go to any 5v and ground point on the motherboard. This can be the pads marked VCC and GND on the bivert module, or the cart connector,