Lectrosonics SMQV Digital Hybrid Wireless UHF Beltpack Transmitter with Dual Battery, 470 470.100 - 495.675 MHz

Lectrosonics SMQV Digital Hybrid Wireless UHF Beltpack Transmitter with Dual Battery, 470 470.100 - 495.675 MHz To meet the demand for both extended operating range and extended battery life, the "V" series SM transmitters offer selectable output power (See specific model data sheets for details). A third selection at 50 mW is provided for some theatrical applications where the system design specifies lower transmitter power. The input section features the unique servo bias input circuitry with a standard TA5M type jack for use with electret lavaliere mics, dynamic mics, or line level signals. A DSP-controlled analog audio limiter is employed before the A-D converter. The limiter has a range of more than 30 dB for excellent overload protection and a dual release envelope that makes the limiter acoustically transparent while maintaining low distortion. The limiter recovers quickly from brief transients, with no audible side effects, and also recovers slowly from sustained high levels to keep audio distortion low while preserving short term dynamics. Key Features Digital Hybrid Wireless™ Technology* (U.S. Patent #7,225,135) Variable, selectable power output 50mW, 100mW, 250mW (for X and US units, blocks 470-23) Membrane switch control panel with LCD display Wide input dynamic range DSP based pilot-tone signal Circulator/Isolator output stage Splash-proof, machined aluminum housing Non-corrosive, super-hard finish Technical Specifications Operating frequencies Block 470 470.100 - 495.675 Block 19 486.400 - 511.975 Block 20 512.000 - 537.575 Block 21 537.600 - 563.175 Block 22 563.200 - 588.775 Block 23a 588.800 - 607.950 Channel Spacing Selectable; 25 or 100 kHz Frequency selection Control panel mounted membrane switches RF Power output Selectable; 50, 100 or 250 mW Compatibility Modes Nu Hybrid, Mode 3, IFB Pilot tone 3.5 kHz deviation (in Nu Hybrid Mode) Frequency stability ± 0.002% Spurious radiation Compliant with ETSI EN 300 422-1 v1.4.2 Equivalent input noise -125 dBV, A-weighted Input level If set for dynamic mic: 0.5 mV to 50 mV before limiting. Greater than 1 V with limiting. If set for electret lavaliere mic: 1.7 uA to 170 uA before limiting. Greater than 5000 uA (5 mA) with limiting. Line level input: 17 mV to 1.7 V before limiting. Greater than 50 V with limiting. Input impedance Dynamic mic 300 Ohms Electret lavaliere; Input is virtual ground with servo adjusted constant current bias Line level 2.7 k Ohms Input limiter Soft limiter, 30 dB range Bias voltages Fixed 5 V at up to 5 mA; Selectable 2 V or 4 V servo bias for any electret lavaliere. Gain control range 44 dB; panel mounted membrane switches Modulation indicators Dual bicolor LEDs indicate modulation of -20, -10, 0, +10 dB referenced to full modulation. Controls Control panel with LCD and four membrane switches. Low frequency roll-off Adjustable from 35 to 150 Hz. Audio Frequency Response 35 Hz to 20 kHz, +/-1 dB Total Harmonic Distortion 0.2% typical (Nu Hybrid mode) Audio Input Jack Switchcraft 5-pin locking (TA5F) Antenna Flexible, unbreakable, detachable steel cable. Batteries 1.5 Volt AA (Lithium recommended) Weight with Battery SMV 2.7 oz. (75.9 grams) SMQV 3.7 oz. (105 grams) Overall Dimensions SMV 2.3 x 1.8 x 0.64 inches, 58 x 46 x 16 mm SMQV 2.3 x 2.4 x 0.64 inches, 58 x 60 x 16 mm Emission Designator 110KF3E Included Accessories 2 - AA Lithium Batteries 1 - Foam Insulating Pads (Part #35924) 1 - Pouch (Part #PSMD) 1 - Mic Connector Kit (Part #SMKITTA5) 1 - Belt Clip (Part #SMDBCSL) 1 - Quick Start Guide