DPA 2006C Compact Twin Diaphragm Omnidirectional Microphone

DPA 2006C Compact Twin Diaphragm Omnidirectional Microphone

$975.00
{{option.name}}: {{selected_options[option.position]}}
{{value_obj.value}}

DPA 2006C Compact Twin Diaphragm Omnidirectional Microphone Our unique Twin Diaphragm Omni Mic Capsule is at the heart of these amazing microphones. This capsule gives the mic a distinctive, well-balanced sound and bridges the gap between the extreme sound quality of our pencil microphones and our well-known lavalier microphones. Combine it with the preamp of your choice As with all of our modular pencil microphones, you can combine the Twin Diaphragm Omni Mic Capsule with any of our preamps. The MMP-A Mic Preamp is an ultra-transparent, transformerless preamp with active drive for impedance balancing. The MMP-C Compact Mic Preamp is an ultra-compact preamp with active drive for impedance balancing. It has a slightly softer character than the other preamps for our pencil microphones. Other preamps include the very small form factor types MMP-E Modular Active Cable (XLR output) and MMP-G Modular Active Cable (MicroDot output), allowing for very slim set-ups. The MMP-G even allows you to match a larger microphone directly to a wireless transmitter. The 2006C Compact Twin Diaphragm Omni Mic offers a subtle character alteration with a bit more “body” to the low end than the 2006A. It is also much easier to position than other omni mics, due to its smaller size. At any time, and with no tools needed, it is possible to transform the 2006 Twin Diaphragm Omni Mic into a new configuration. Technical Specifications Directional pattern Omnidirectional Principle of operation Pressure Cartridge type Pre-polarized condenser, Twin Diaphragm Capsule Frequency response 20 Hz - 20 kHz Effective frequency range +/-2 dB 50 Hz - 20 kHz with typ. 3 dB soft boost at 14 kHz Sensitivity, nominal, +/-2 dB at 1 kHz 40 mV/Pa; -28 dB re. 1 V/Pa Equivalent noise level, A-weighted Typ. 16 dB(A) re. 20 uPa (max. 18 dB(A)) Equivalent noise level, ITU-R BS.468-4 Typ. 28 dB (max. 30 dB) Distortion, THD < 1% 127 dB SPL RMS, 130 dB SPL peak Dynamic range Typ. 114 dB Max. SPL, THD 10% 139 dB SPL peak Rated output impedance 100 OHM Minimum load impedance 2 k OHM Cable drive capability 100 m (328 ft) Output balance principle Impedance balancing with Active Drive Common mode rejection ratio (CMRR) > 50 dB Power supply (for full performance) P48 (Phantom Power) Current consumption 2.8 mA Connector XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase Color Matte black Weight 60 g (2.1 oz) Microphone diameter 19 mm (0.75 in) Microphone length 58 mm (2.3 in) Maximum output voltage, RMS 4.5 V Polarity +V at pin 2 for positive sound pressure Temperature range -40C to 45C (-40F to 113F) Relative humidity (RH) Up to 90% Sensitivity selection tolerance (at 1 kHz) +/-1.5 dB

Show More Show Less